EBP A

catalog (PDF)

Vertical drop-down electric lock, for automated swinging gates. The product is an important accessory for completing the installation in order to safeguard gear motors installed on large gates. It is also an essential element for locking the leaves when gates are equipped with reversible operators. Available in 230V, 120V and in the new 24V version, it is directly connected to the control unit. The wide operating temperature range of -20°C +55°C allows it to be used in a large number of applications.

Main features

Higher protection for the installation: the electric lock makes it possible to create installations that better withstand the forces applied to the leaves in swinging gates, especially large ones, such as pushes from people or forces generated by the action of the wind. These forces are transferred to the electromechanical lock instead of the gear motor, providing a longer life and better operation over time

Offer completion for reversible operators: the electric lock is an essential accessory for installations involving the use of reversible operators, in order to provide locking for the gate when closing

Range extension: the new EBP A model in 24V, which is directly connected to the control unit, allows safe low-voltage swing gate installations to be completed easily and quickly

Range optimisation: there will no longer be any specific electric lock models (EBPE) with an external (road side) key block. In all models of the new EBP A it is possible at any time to add the external key block, which is available in two sizes of 52 or 75 mm. The accessory also includes the inside key block, which has the same key as the outside key block, and which should be replaced with the one on the electric lock by the installer

Outward opening: the EBP A electric lock can be installed either on swing gates that open inwards or on gates that open outwards (the plate with the ground hole must be installed in the correct direction)

Simplicity of a single key for the entire system: it is possible to request the new EBP A with a specific internal key block, or request accessories with internal and external blocks with a specific key number, so that the same key can be used to unlock the operator, operate the selector switch and release the electric lock

Design: the look of the product has been updated - in line with Bft's modern style - allowing it to be perfectly integrated into the installation environment

Products list

  • News

230V vertical electric lock.

  • News

24V vertical electric lock.

  • News

120V vertical electric lock.

  • Phase Out

Electric lock 220-230V 50/60Hz with zero stop resistance

  • Phase Out

Electric lock 120/230V 50/60Hz with 230/24V transformer which can be installed on the control panel

  • Phase Out

Electric lock 220-230V 50/60Hz with zero stop resistance, also with external release for gates of max. thickness 52 mm.

  • Phase Out

EBPE 52 120/230V 50/60Hz with transformer

  • Phase Out

Electric lock 220-230V 50/60Hz with zero stop resistance, also with external release for gates of max. thickness 75 mm.

  • Phase Out

Electric lock 120V 50/60Hz with 230/24V transformer which can be installed on the control panel

Accessories

CSE 52 (EXTERNAL RELEASE EBP 52 MM)
P123033

Key cylinder for external release for gates of max. thickness 50 mm. Also includes internal key cylinder with same key number.

CSE 75 (EXTERNAL RELEASE EBP 75 MM)
P123034

Key cylinder for external release for gates of max. thickness 75 mm. Also includes internal key cylinder with same key number.